Golf L4-2.0L (AZG) (2004)
/Page-1493002.png)
-
Measure dimension -a- at three different outer holes of drive plate (120° offset) and calculate average.
Specification: 19.5 to 21.1 mm
Note: Measure through hole in drive plate to milled surface of cylinder block. To do this unhook intermediate plate, Refer to Fig. 1).
If the specification is not attained:
-
Remove drive plate again and install shim -2-. Again tighten bolts -3- to 30 Nm.
-
Tighten bolts to 60 Nm plus an additional 90° (1/4 turn) (turning further can be done in several stages).
