Golf L4-2.0L (BEV) (2004)
Spoiler: Service and Repair
Rear Spoiler With Rear Lid Change, Removing and Installing
Rear Spoiler With Rear Lid Change, Removing And Installing
Rear lid preparation
-
Cut installation template as indicated and paste it to vehicle rear lid following illustrated dimensions.
-
With a soft pencil or crayon, draw outline of gray shapes - a - directly on vehicle surface
-
Drill holes to rear lid as indicated on Installing Template
-
Remove Installing Template
-
Apply scotch tape to outer borders of outlined surfaces to mask them before primer application
-
Clean thoroughly with alcoholic cleaner and then apply primer to outlined surfaces (three surfaces) on top of rear lid - a and allow to dry
Installing
-
Apply primer to base of spoiler (three surfaces) - 1 - and allow to dry
-
Apply adhesive material to the base of spoiler (three surfaces) - 1 - using VAS 5237
NOTE: Spoiler has to be attached to rear lid of vehicle within 5 minutes after adhesive has been applied, otherwise adhesive will loose
effectiveness
-
Attach spoiler to rear lid of vehicle making sure that the drilled holes match with the attaching holes on spoiler
-
Route stoplight wiring harness through the center hole drilled pulling it firmly to make grommet fit