Golf L4-2.0L (BEV) (2004)
-
Raise vehicle.
-
Disconnect wheel speed sensor wiring connector -1-.
-
Remove bolt -2- from wheel bearing housing.
-
Remove wheel speed sensor from wheel bearing housing.
Installing
-
Before inserting speed sensor, clean mounting hole inner surface and coat sensor with lubricant G 000 650.
-
Insert speed sensor into mounting hole in wheel bearing housing and tighten bolt to 8 Nm (70 inch lbs.).
-
Connect wheel speed sensor wiring connector.
-
Turn wheels fully to left and right lock and check clearance of speed sensor ring.
ABS wheel speed sensor rotor for front axle, checking
-
Raise vehicle.
-
Remove wheel.
-
Rotate brake disc and check whether wheel speed sensor rotor is damaged or dirty.
-
If rotor is damaged, remove wheel hub with rotor and replace.
ABS wheel speed sensor gap, checking
-
Raise vehicle.
-
Remove wheel.
-
Turn wheel hub and measure distance between rotor and speed sensor, -dimension a-, all around.
-
Dimension a = 0.3 mm (0.0118 inch)
-
If the rotor is not true, remove wheel hub with rotor and replace.
Front wheel speed sensor wiring, removing and installing