Golf L4-2.0L (BEV) (2004)
-
The engine/transmission angle has changed and therefore the lower edge of the oil fill hole -1- is located below the new oil level -2-.
-
To properly check oil level, transmission must be drained completely and re-filled.
Tip:
The transmission housing must be cleaned and dried before servicing.
Shift fork pins must be removed in order to drain transmission.
Selector shaft, securing
^
Remove air cleaner housing.
^
Remove sound insulation.
^
Clean and dry transmission.
^
Secure selector shaft so that the position of shift fork pins can not move:
^
Press selector shaft down arrow -1-
^
While selector shaft is held in down position, turn bracket -A- upward (clockwise) in direction of arrow -2- and press inward until the bracket latches
in selector shaft.
Tip:
Use a clean 3.0L container with graduated markings to catch draining oil Transmission, draining