Golf L4-2.0L (BEV) (2004)
-
Rotate front wheel, and observe voltage indicated while doing so.
Specified value: 0.0 to at least 4.0 V, fluctuating
NOTE: The right front wheel must not turn during this, hold it steady if necessary.
If indicated voltage does not oscillate:
-
Remove instrument cluster.
-
Check wire connection from Engine Control Module (ECM) to Speedometer -G21- according to wiring diagram.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan Tool
Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.