Golf L4-2.0L (BEV) (2004)
Engine Control Module: Component Tests and General Diagnostics
Voltage Supply For Engine Control Module (ECM), Checking
Recommended special tools and equipment
-
V.A.G 1526 multimeter or V.A.G 1715 multimeter
-
V.A.G 1594 connector test kit
-
Wiring diagram
Requirements
-
The respective fuses of Motronic Engine Control Module (ECM) -J220- must be OK:
-
Fuel Pump (FP) relay -J17- must be OK, check:
-
Generator (GEN) must be OK, checking:
-
Battery voltage must be at least 11.5 Volts.
-
All electrical consumers such as, lights and rear window defroster must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
For vehicles with automatic transmission, selector lever must be in position -P- or -N-.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
Work sequence
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test
Checking voltage supply at terminal 30
Vehicles with engine code AEG
-
Measure voltage supply between sockets 2 + 3 of test box.
Specified value: at least 11.5 V
Vehicles with engine code AVH, AZG, BBW, BEV
-
Measure voltage supply between sockets 1 + 62 and 2 + 62 of test box.
Specified value: at least 11.5 V
If specified value is not obtained:
-
Check wire connections to relay carrier and Ground (GND) connection of Engine Control Module (ECM) according to wiring diagram:
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data. See: Computers and Control
Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
Checking voltage supply at terminal 15
Vehicles with engine code AEG
-
Measure voltage supply between sockets 1 + 2 of test box.
Vehicles with engine code AVH, AZG, BBW, BEV
-
Measure voltage supply between sockets 1 + 3 and 2 + 3 of test box.