Golf L4-2.0L (BEV) (2004)
Air Bag Control Module: Service and Repair
Airbag Control Module -J234-, Removing And Installing
Removing
-
Disconnect battery Ground (GND) strap.
-
Remove trim/footwell - 5 -.
CAUTION: Observe safety precautions for working on airbags.
-
Fold bracket - 2 - opposite direction of - arrow - and disconnect connector - 3 - from control module - 1 -.
-
Remove nuts - 4 - (qty. 3, 6 Nm) and remove control module from studs.
Installing
-
Installation is reverse of removal.
-
Switch ignition on.
CAUTION: Make sure no one is in vehicle.
-
Connect battery Ground (GND) strap.
-
If control module was replaced, it must be coded, adapt (code) components.