Golf L4-2.0L (BEV) (2004)
^
Install in mounting bracket
^
To replace, remove and install clutch master cylinder
18- Clutch pedal switch -F36-
^
When removing and installing switch, push clutch pedal down as far as possible by hand.
^
Before removing the clutch pedal, remove switch with left turn of 45° and pull out from support through mounting hole.
^
Insert switch in mounting hole and secure with right turn of 45°.
19- Stop flange
^
For clutch pedal
20- Hex nut, self- locking 25 Nm
^
Always replace
Clutch Pedal & Over-Center Spring, Removing & Installing
Clutch Pedal & Over-Center Spring, removing & Installing
Overcenter spring, removing and installing
Special tools and equipment
^
T10111 Assembly device
Removing
^
Remove cover/lower drivers side.
^
Insert assembly device T10111 in overcenter spring from right side.
^
Make sure that assembly device seats correctly on overcenter spring:
1 - Assembly device must fit exactly onto overcenter spring rear part, with claws over bridge -1-.
2 - Lightly press clutch pedal in direction of bulkhead.
Hang assembly device tab -2- in overcenter spring cut out.
^
Press clutch pedal to bulkhead until overcenter spring can be taken out of support mountings and clutch pedal.
^
Make clutch pedal recede even more until it is in rest position.