Golf L4-2.0L (BEV) (2004)
-
Next, insert Bowden cable -2- coming from above into lower, shallow groove.
NOTE: Bowden cables must not cross.
-
Fold up coupling plate with clamping brackets -1- in direction of -arrow- toward guide rail -2-.
-
Install second coupling plate with clamping brackets -1- as described.
Thread in Bowden cable onto relay pulley
-
Check 4 ends of Bowden cable sheathings for correct seating in mounts - arrow -.
-
Route Bowden cable -1- onto eccentric washer of relay pulleys -2- as depicted in illustration.
-
All eccentric washers must be rotate to lowest height, otherwise it is very difficult to install Bowden cable onto last relay pulley.
-
Remove securing plate -2- from cable reel -1-.
-
Pull both coupling plates with clamping brackets up to lower end of guide rails. When doing this, Bowden cable slide automatically into relay
pulley grooves.
-
Check position of Bowden cable.
Bowden cable must be located correctly in groove at all 4 relay pulleys.
-
Slide coupling plates with clamping brackets back and forth several times on guide rails to check them for proper function.
Vehicles with electrical window regulators
-
Place foam shims contained in repair set between window regulator motor and carrier assembly.
-
Install motor for window regulator.
-
Tighten bolts to 3.5 Nm.