Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Depending on vehicle equipment, disconnect wiring harnesses from compartment.
Installation
-
To install, perform the steps used for removal in reverse order.
‹› Before installing, check securing clips for damage and replace if necessary.
Luggage Compartment Side Trim
‹› Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the
same manner.
Removing
-
Switch off ignition.
-
Remove floor covering from vehicle.
2-door vehicles
-
Remove upper B-pillar trim. Belt anchor or belt anchor rail do not need to be removed from front seat belt. Refer to => [ Upper B-Pillar Trim ]
See: Interior Moulding / Trim/Trim Panel/Service and Repair/Table of Contents.
-
Remove seat bench. Refer to => [ Bench Seat ] See: Seats/Service and Repair/Removal and Replacement/Table of Contents Seat Frames.
-
Remove backrest. Refer to => [ Backrest ] See: Seats/Service and Repair/Removal and Replacement/Table of Contents Seat Frames
-
Remove side trim. Refer to => [ Side Trim, 2-door ] See: Interior Moulding / Trim/Trim Panel/Service and Repair/Table of Contents