Golf L4-2.0L DSL Turbo (CJAA) (2010)
‹› When doing this, the clips will be destroyed and must be replaced.
‹› For illustrative purposes, the illustration shows the subframe removed and from the top.
-
Lower subframe with attachments.
Subframe with Components, Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
-
Perform a vehicle alignment. Refer to => [ Wheel Alignment ] See: Maintenance/Alignment/Service and Repair/Wheel Alignment.
Tightening Specifications
Subframe
All Wheel Drive (AWD)
Subframe
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
‹› Engine/transmission jack (V.A.G 1383 A )
Subframe with Components, Removing
‹› Be aware that if there is additional work where the drive axle twelve point bolt must be loosened, this must also occur with the vehicle resting on
the wheels. Remove the drive axle twelve point bolt. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Steering and
Suspension/Suspension/Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive (AWD).
-
Remove wheels.