Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Replace the bracket bolts one after the other with (T10096 ) and tighten to 20 Nm.
Securing Console
Position of front axle is now secured.
Lower the subframe further. Refer to => [ Remove the bolts and and lower the subframe 10 mm maximum See: Removal and Replacement/Front
Suspension.
Continue removing the subframe without the steering gear. Refer to => [ steering gear bolts and. ] See: Cross-Member/Front Cross-Member/Service
and Repair/Front Suspension/Subframe Without Steering Gear.
Continue removing the subframe with the steering gear. Refer to => [ under
subframe. ] See: Cross-Member/Front Cross-Member/Service and Repair/Front Suspension/Subframe With Steering Gear.
Continue with removing stabilizer. Refer to => [ Remove the stabilizer from subframe and ] See: Steering and Suspension/Suspension/Stabilizer
Bar/Service and Repair/Front Suspension/Stabilizer Bar.
Steering gear, removing and installing, refer to => [ Place the under the subframe. ] See: Steering and Suspension/Steering/Steering Gear/Service and
Repair/Removal and Replacement/Steering Gear.
Removing (T10096)
Removal is performed in the reverse order of installation. Make sure that the (T10096) are replaced one after the other with new bolts.
Tightening Specifications