Golf L4-2.0L DSL Turbo (CJAA) (2010)
Installation
-
To install, perform the steps used for removal in reverse order.
‹› Ensure trim is in door seal molding after installation.
Driver Side Lower A-Pillar Trim
Removing
-
Disengage sill panel trim from body in lower A-pillar trim transition area.
‹› 2-door => [ Sill Panel Trim, 2-door ] See: Scuff Plate/Service and Repair
‹› 4-door => [ Sill Panel Trim, 4-door ] See: Scuff Plate/Service and Repair
-
Remove side instrument panel covers. Refer to => [ Instrument Panel Side Covers ] See: Utility Storage Compartment/Service and Repair
-
Remove hood operating lever - 1 -.
-
Remove clip - 2 -.
-
Remove trim from body - arrow A -.
-
Remove trim from door seal piping.
-
Pull trim out of mount - arrow B -.
‹› Before installation, clip - 2 - must be checked for damage and replaced if necessary.