Golf L4-2.0L DSL Turbo (CJAA) (2010)
‹› without rear side airbags => [ Side Upholstery, 4-door ] See: Seats/Service and Repair/Removal and Replacement/Table of Contents Seat Frames
-
Wheel housing trim, 4-door, removing => [ Wheel Housing Trim, 4-door ] See: Scuff Plate/Service and Repair
4-door vehicles with rear side airbag, from 06.2005
-
Remove 4-door side upholstery:
‹› with rear side airbags => [ Side Upholstery with Side Airbag, 4-door ] See: Seats/Service and Repair/Removal and Replacement/Table of Contents
Seat Frames
-
Wheel housing trim, 4-door, removing => [ Wheel Housing Trim, 4-door ] See: Scuff Plate/Service and Repair
4-door vehicles without rear side airbag, from 06.2005
-
Remove wheel housing trim on 4-door vehicles without rear side airbag => [ Wheel Housing Trim, 4-door, without rear side airbag from 06/2005 ]
See: Scuff Plate/Service and Repair
2-door vehicles
-
Remove upper B-pillar trim. Belt anchor or belt anchor rail do not need to be removed from front seat belt => [ Upper B-Pillar Trim ]
-
Remove seat bench => [ Bench Seat ] See: Seats/Service and Repair/Removal and Replacement/Table of Contents Seat Frames.
-
Remove backrest => [ Backrest ] See: Seats/Service and Repair/Removal and Replacement/Table of Contents Seat Frames
-
Remove side trim => [ Side Trim, 2-door ]
All vehicles
-
Remove luggage compartment cover side compartment => [ Luggage Compartment Cover Side Storage Compartment ] See: Doors, Hood and
Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and Repair/Luggage Compartment Trim.
-
Remove roof end strip => [ Roof End Strip ] See: Headliner/Service and Repair
-
Remove airbag emblem - 1 - and remove screw - 2 - (4 Nm).
‹› When re-installing, airbag emblem - 1 - must be replaced.
-
Remove nut - 3 - (1.5 Nm).
-
Loosen trim from threaded pins in nut - 3 - - arrow A -.
-
Remove trim from mounts - arrow B - and door seal piping.
-
Remove trim upward out of mounts in body - arrow C -.