Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Remove the engine cover.
Diesel Engines With and Without a Particulate Filter
-
Remove the plenum chamber cover.
-
Remove the plenum chamber bulkhead.
Diesel Engines With a Particulate Filter
-
Remove the exhaust pressure sensor 1 (G450), disconnect the electrical connectors, remove the particulate filter and lower it.
Continuation for All Vehicles
-
Remove the heat shield, if equipped.
-
Release the control module connector in the direction of arrow - 1 - and pull off in the direction of arrow - 2 -.
-
Install the (V.A.G 1869/2).
-
Attach the bleeder hoses from the bleeder bottles to the left front and left rear brake caliper bleeder valves and open the valves.
-
Press the brake pedal using the (V.A.G 1869/2) at least 60 mm.
-
Close the left front and left rear bleeder valves.
-
DO NOT remove the (V.A.G 1869/2).
-
Place sufficient lint free cloths under the control module and hydraulic unit.
Make sure that brake fluid does not come in contact with the terminals.
-
Mark both brake lines from the master cylinder - A and B - and remove them from the hydraulic unit.