Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Seal off the brake lines and the threaded holes right away with plugs from repair kit 1H0 698 311 A.
-
Mark the brake lines from the brake calipers - 1 through 4 -, remove them and seal the lines and holes.
-
Remove the bolt from the bracket.
-
Remove the hydraulic unit, the control module and the retainer from the bracket rubber insulators and turn it on its head.
-
Remove the retainer from the hydraulic unit in the engine compartment.
-
Remove the hydraulic unit and the control module.
Control Module, Removing from Hydraulic Unit
-
Set the hydraulic unit with control module upward onto a clean, level surface.
-
Remove the TORX bolts from the control module.
-
Remove the control module off from the hydraulic unit - arrow - without tilting it.