Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Using a compressed air gun, carefully blow coolant out of heater core into container - B -.
Depending on the engine, additional parts may need to be removed such as the charge air pipe.
-
Slightly loosen (do not remove) screw - 1 - on connecting flange between heater core connections.
‹› By loosening the screw - 1 -, the coolant pipes are loosened and it is easier to remove the heater core.
-
Remove the knee airbag.
-
Remove the driver side footwell vent. Refer to => [ Driver Side Footwell Vent ] See: Heating and Air Conditioning/Air Register/Service and
Repair/Vents.
-
Remove screws - A - and remove trim - B -.
‹› There are different versions of cover - B -.
‹› The illustration shows the version with auxiliary air heater heating element (Z35).
‹› If the temperature door lever - C - is a position that hinders access to the upper screw - A -. Change the position of the temperature door using the
controls for hot air and fresh air, on vehicles with Climatronic with operating and display unit, for example, the HI setting.
-
Cover carpet in area under heat exchanger with waterproof foil and water absorbing paper.