Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Remove the fuel injectors. Refer to => [ Fuel Injection Unit ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service
and Repair.
-
Remove the cylinder head cover bolts and cover.
Installing
Installation is performed in reverse order. When doing this note the following:
‹› Replace the gaskets for the bolts if damaged.
-
Hand tighten the cylinder head cover bolt in sequence 1 through 7.
-
Tighten the bolts in sequence 1 through 7 to 10 Nm.
-
Make sure the cylinder head cover is correctly attached to the toothed belt guard.
‹› The camshaft sprocket is not shown in the illustration.
-
Press the toothed belt guard in the area with the clips - arrows - against the cylinder head cover until the clips engage with each other. Use a
screwdriver to press the guard if necessary.