Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Disconnect the connector from the oil level thermal sensor (G266).
-
Remove the oil pan to transmission bolts.
-
Remove the oil pan to cylinder block bolt diagonally.
-
Loosen the oil pan with light blows from a rubber mallet if necessary.
-
Remove any sealant residue from the cylinder block with a flat blade scraper.
CAUTION!
Wear safety glasses.
-
Remove any sealant residue from the pan using a hand drill with a plastic brush attachment (wear eye protection).
-
Clean the sealing surfaces. They must be free of oil and grease.
Installing
‹› Note the expiration date of the sealing compound.
‹› The oil pan must be installed within 5 minutes after application of silicone sealant.
-
Cut the tube nozzle at the front mark (nozzle diameter approximately 3 mm).