Golf L4-2.0L DSL Turbo (CJAA) (2010)
Crankshaft Main Bearing Seal: Service and Repair
Sealing Flanges and Flywheel Assembly Overview
Sealing Flanges and Flywheel Assembly Overview
Servicing the Clutch
1
Seal
‹› Do not lubricate or grease the sealing lip of the oil seal.
‹› Before installing, remove any remaining oil from crankshaft with a clean cloth.
‹› Crankshaft seal - ribbed belt side, replacing. Refer to => [ Crankshaft Seal ] See: Front Crankshaft Seal/Service and Repair.
2
Sealing Flange, Belt Pulley Side
‹› Must be located on the alignment bushings.
‹› Removing and installing, refer to => [ Sealing Flange, Belt Pulley Side ] See: Cylinder Block Assembly/Sealing Flange, Engine Front/Service
and Repair.
‹› Install using silicone sealant (D 176 404 A2 ). Refer to => [ Sealing Flange, Belt Pulley Side ] See: Cylinder Block Assembly/Sealing Flange,
Engine Front/Service and Repair.
3
Cylinder Block
‹› => [ Crankshaft Assembly Overview ] See: Cylinder Block Assembly/Crankshaft/Service and Repair/Crankshaft Assembly Overview.