Golf L4-2.0L DSL Turbo (CJAA) (2010)
Crankshaft Main Bearing Seal: Service and Repair
Sealing Flange, Flywheel Side
Sealing Flange With Sensor Wheel, Removing
Sealing Flange, Flywheel Side
Special tools, testers and auxiliary items required
‹› Assembly Tool (T10134)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Tool Insert AF24 (V.A.G 1332/11)
‹› Caliper Gauge
‹› Three M6 x 35 Bolts
‹› Two M7 x 35 Bolts
Sealing Flange with Sensor Wheel, Removing
-
Remove the transmission.
-
Remove the flywheel.
-
Remove the intermediate plate.
-
Rotate the crankshaft to Top Dead Center (TDC) cylinder 1 as illustrated.
-
Remove the oil pan. Refer to => [ Oil Pan ] See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan.
‹› The engine is shown in the illustrations removed.
‹› The procedures are the same with the engine installed and removed.
-
Remove the engine speed (RPM) sensor (G28) - arrow -.