Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-352009.png)
-
Install the nut - E - onto the threaded spindle by hand, until it rests on the assembly bell - C -.
Installing the Sensor Wheel to the Crankshaft With the T10134
Sealing Flange, Flywheel Side
Special tools, testers and auxiliary items required
‹› Assembly Tool (T10134)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Tool Insert AF24 (V.A.G 1332/11)
‹› Caliper Gauge
‹› Three M6 x 35 Bolts
‹› Two M7 x 35 Bolts
Installing the Sensor Wheel to the Crankshaft with the T10134
-
Tighten the nut on the (T10134) to 35 Nm using (V.A.G 1331) and (V.A.G 1332/11).
‹› After tightening the nut to 35 Nm, a minimal air gap must still be present between the cylinder block and sealing flange.
Sensor Wheel to Crankshaft, Checking Installed Position
Sealing Flange, Flywheel Side
Special tools, testers and auxiliary items required
‹› Assembly Tool (T10134)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Tool Insert AF24 (V.A.G 1332/11)
‹› Caliper Gauge
‹› Three M6 x 35 Bolts
‹› Two M7 x 35 Bolts
Sensor Wheel to Crankshaft, Checking Installed Position
