Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-352013.png)
-
Push the (T10134) onto the sealing flange by hand.
-
Install the nut - E - onto the threaded spindle by hand, until it rests on the assembly bell - C -.
-
Tighten the nut on the (T10134) to 40 Nm using a (V.A.G 1331) and (V.A.G 1332/11).
-
Check the installed position of the sensor wheel on the crankshaft again.
If dimension - a - is too small:
-
Tighten the nut on the (T10134) to 45 Nm.
-
Check the installed position of the sensor wheel on the crankshaft again.
