Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Carefully turn the tensioning roller eccentric pulley clockwise using (T10264). The pointer - 2 - must be somewhat above the center of the gap in
the base plate. This will be corrected when pre-tensioning.
Make sure the nut - 1 - does not rotate with it.
-
Hold the tensioning roller in this position and tighten the nut to 20 Nm + 45° (1/8) additional turn.
-
Position the (T10172) as illustrated. Push the (T10172) in the - direction of the arrow - and hold the camshaft sprocket pre-tensioned.
-
Tighten the bolts - 1 - for the camshaft sprocket and for the high pressure pump belt sprocket hand tight. Then tighten them again to 20 Nm.