Volkswagen Workshop Service and Repair Manuals

‹› Removing and installing, refer to => [ Oil Supply Line to Turbocharger ] See: Engine/Engine Lubrication/Oil Line/Service and Repair.

‹› Before installing, check the oil supply line for clear passage.

‹› Fill with engine oil before installing the turbocharger oil supply line to the connection point.

5

Vacuum Line

‹› Make sure it is seated correctly and is routed without kinks.

‹› To the wastegate bypass regulator valve (N75).

‹› Connection diagram for vacuum lines, refer to => [ Vacuum Line Connection Diagram ] See: Diagrams/Vacuum and Vapor Hose

Diagrams/Turbocharger.

6

Vacuum Diaphragm

‹› With the charge pressure actuator position sensor (G581).

7

Heat Shield

‹› Replace if damaged.

8

Heat Shield

9

Bracket

‹› For the wiring harness.

10

Seal

‹› Replace

11

Securing Clamp

‹› 7 Nm

‹› Replace

‹› Note the installed position, refer to => [ Particulate Filter with Nitrogen Oxide Absorption Catalytic Converter Overview ] See: Continuous

Trap Oxidizer/Service and Repair/Particulate Filter With Nitrogen Oxide Absorption Catalytic Converter Overview.

12

to the Particulate Filter

‹› Refer to => [ Particulate Filter with Nitrogen Oxide Absorption Catalytic Converter Overview ] See: Continuous Trap Oxidizer/Service and

Repair/Particulate Filter With Nitrogen Oxide Absorption Catalytic Converter Overview.

13

Gasket

‹› Replace

‹› Note the installed position.

14

Turbocharger

‹› Part of the exhaust manifold and vacuum diaphragm. 

‹› Removing and installing, refer to => [ Turbocharger ] See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Service

and Repair/Turbocharger.

15

Nut

‹› 23 Nm

‹› Replace