Golf L4-2.0L DSL Turbo (CJAA) (2010)
‹› Engine/transmission jack (V.A.G 1383 A)
‹› Angle wrench (V.A.G 1756)
‹› Spreader (3424)
Removing
-
Remove the drive axle bolt. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and
Repair.
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
-
Remove wheel.
-
Remove brake caliper and engage on body with wire.
-
Remove ABS wheel speed sensor.
-
Remove disc brake.
-
Now remove cover plate from wheel bearing housing.
-
Loosen nut of track rod ball joint, but do not unscrew yet.
‹› To protect thread, screw nut on pin a few turns.
-
Press off track rod ball joint from wheel bearing housing using (3287A) and now unscrew nut.
-
Loosen nuts - arrows -.