Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Press the pins - 3 - together - arrows - and pull the data bus on board diagnostic interface through the holes.
-
Remove Data Bus On Board Diagnostic Interface from vehicle.
Installing:
Install in reverse order of removal.
Driver Door Control Module
Control Modules
Driver Door Control Module
‹› If Driver Door Control Module or Driver Window Regulator Motor is to be replaced, the work procedure Code driver side door control module
must then be performed. Refer to => [ Driver Door Control Module, Coding ] See: Body and Frame/Locks/Door Locks/Door Module/Testing and
Inspection.
Front Passenger Door Control Module
Control Modules
Front Passenger Door Control Module
‹› If Front Passenger Door Control Module or Front Passenger Window Regulator Motor is to be replaced, the work procedure Code front passenger
side door control module must then be performed. Refer to => [ Front Passenger Door Control Module, Coding ] See: Body and
Frame/Locks/Door Locks/Door Module/Testing and Inspection.
Left Rear Door Control Module
Control Modules
Left Rear Door Control Module
‹› If Left Rear Door Control Module or Left Rear Window Regulator Motor is to be replaced, the work procedure Code left rear door control module
must then be performed. Refer to => [ Left Rear Door Control Module, Coding ] See: Body and Frame/Locks/Door Locks/Door Module/Testing
and Inspection.
Right Rear Door Control Module
Control Modules
Right Rear Door Control Module
‹› If Right Rear Door Control Module or Right Rear Window Regulator Motor is to be replaced, the work procedure Code right rear door control
module must then be performed. Refer to => [ Right Rear Door Control Module, Coding ] See: Body and Frame/Locks/Door Locks/Door