Golf L4-2.0L DSL Turbo (CJAA) (2010)
Body Control Module: Service and Repair
Data Bus on Board Diagnostic Interface, LHD
Control Modules
Data Bus On Board Diagnostic Interface, LHD
The data bus on board diagnostic interface is located in the right side of the driver footwell near the steering column.
Removing:
‹› If Data Bus On Board Diagnostic Interface is to be replaced, the work procedure to read out the codes stored in the module must always be
performed => [ Data Bus On Board Diagnostic Interface ]. See: Data Bus on Board Diagnostic Interface
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove the trim in the driver footwell.
-
Disengage harness connector - 1 - and disconnect it from Data Bus On Board Diagnostic Interface - 2 -.
-
Press the pins - 3 - together - arrows - and pull the data bus on board diagnostic interface through the holes.
-
Remove Data Bus On Board Diagnostic Interface from vehicle.
Installing:
Install in reverse order of removal.