Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-425001.png)
Ignition Switch: Service and Repair
Ignition Switch and Lock Cylinder, Through 05.10
Ignition Switch and Lock Cylinder, through 05.10
=> [ Steering Lock Housing ]
=> [ Lock Cylinder ]
=> [ Ignition Switch ]
=> [ Ignition Switch Key Lock Solenoid ]
Steering Lock Housing
CAUTION!
When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information. Refer to => [
Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery, Disconnecting and Connecting.
‹› To remove steering lock housing, it is first necessary to remove base carrier for steering column switches.
CAUTION!
‹› Steering lock may be destroyed.
‹› If steering lock is operated without lock cylinder, it locks and must be replaced.
‹› Steering lock must not be operated without lock cylinder.
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery,
Disconnecting and Connecting.
-
Remove base carrier for steering column switches. Refer to => [ Steering Column Combination Switch, Through 05.10 ] See: Lighting and
Horns/Sensors and Switches - Lighting and Horns/Combination Switch/Description and Operation/Steering Column Combination Switch, Through
05.10.
Lock Cylinder
CAUTION!
‹› When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information. Refer to => [
Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery, Disconnecting and Connecting.
‹› Steering lock may be destroyed.
‹› If steering lock is operated without lock cylinder, it locks and must be replaced.
‹› Steering lock must not be operated without lock cylinder.
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery,
Disconnecting and Connecting.
-
Remove steering column trim.
‹› the turn signal switch, the windshield wiper switch, the steering angle sensor, the spiral spring, the steering wheel and the steering column
electronic systems control module are not shown in the illustration. Components must not be removed when removing lock cylinder.
‹› The immobilizer induction coil is attached to the lock cylinder and cannot be replaced separately.
‹› To improve clarity, the ignition key is not shown in the following illustrations.
‹› The hole can be located opposite 180° as shown in the illustration. This does not affect removing and installing.
