Golf L4-2.0L DSL Turbo (CJAA) (2010)
1
Position Off
2
Position Run
3
Position Start
-
Install all the components in reverse order of removal.
Ignition Switch, Vehicles With KESSY
Ignition Switch and Lock Cylinder, from 06.10
Ignition Switch, Vehicles with KESSY
Vehicles with KESSY have a start system button on the steering column rather than the usual ignition switch.
Start System Button, Removing and Installing, refer to => [ Access/Start Authorization Button, KESSY ] See: Accessories and Optional
Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Starting System/Description and Operation.
Ignition Switch Key Lock Solenoid
Ignition Switch and Lock Cylinder, from 06.10
Ignition Switch Key Lock Solenoid
The ignition switch key lock solenoid must be mounted next to the ignition switch.
‹› To remove key on a vehicle with a DSG transmission, move the selector lever into P and then switch off the ignition. Otherwise, ignition switch
key lock solenoid prevents the key from being removed!
Removing:
-
Remove steering column trim.
-
Release locking device - 2 - using a suitable screwdriver.
-
Pull Ignition Key Removal Lock Solenoid - 1 - in direction of arrow out of its mount.
-
During this, harness connector is simultaneously disconnected.
Installing:
-
Install in reverse order of removal, noting the following:
‹› After connecting the battery, activate the ignition switch key lock solenoid by performing an output diagnostic test.