Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-967003.png)
‹› Note the special instructions for the driver and passenger airbags.
-
Disconnect vehicle battery.
-
Adjust steering wheel height to the highest position.
-
Adjust steering wheel depth (reach) so it is in the fully extended position.
-
Turn steering wheel into the position depicted.
-
Insert a screwdriver into hole on rear side of steering wheel until it stops (approx. 8 mm).
-
Turn the screwdriver in the direction of passenger side door - arrow -; this unlocks the airbag unit locking frame on the right side of the steering
wheel.
‹› If it is not a multifunction steering wheel, then the airbag must be from the steering wheel bezel on the upper edge after actuating the lock.
-
Turn steering wheel 180° and disengage airbag unit locking mechanism on left side of steering wheel as described.
‹› If it is not a multifunction steering wheel, then the airbag must be from the steering wheel bezel on the upper edge after actuating the lock.
-
Turn steering wheel back 90° into center position.
-
Remove airbag unit from steering wheel.
CAUTION!
Electrostatic discharges can lead to an unintended deployment of the airbag. Therefore the technician must discharge static electricity
from the body before separating the ignition and ground wiring. This is done, for example, by briefly touching the body or the door
striker or pin.
