Golf L4-2.0L DSL Turbo (CJAA) (2010)
CAUTION!
Make sure that no persons are in the vehicle.
-
Connect vehicle battery.
Rear Side Airbag, 4-Door
Airbag
Rear Side Airbag, 4-door
‹› Removal and installation is described for the right-hand side of the vehicle. Removal and installation for the left-hand side is performed in the
same manner.
Removing
CAUTION!
Read the Safety Instructions for working with airbags, belt tensioners and battery cut-out units. Refer to => [ Airbag, Belt Tensioner and
Battery Cut-Out Units General Safety Precautions ] See: Service Precautions/Airbag, Belt Tensioner and Battery Cut-Out Units General
Safety Precautions.
-
Disconnect vehicle battery.
-
Remove seat bench. Refer to => [ Bench Seat ] See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Table of Contents Seat
Frames.
-
Remove side upholstery with side airbag, 4-door, - 1 -. Refer to => [ Side Upholstery with Side Airbag, 4-door ] See: Body and
Frame/Seats/Service and Repair/Removal and Replacement/Table of Contents Seat Frames
-
Remove the two bolts - 2 - (9 Nm).
‹› The bolts are microencapsulated and must therefore be replaced after every removal.
‹› Before installing the new bolts, the threads of the corresponding nuts must be cleaned.
-
Remove rear side airbag connector coupling - 3 - from mount in side upholstery - 1 -.
-
Remove rear side airbag - 3 - from side upholstery.