Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-636006.png)
5903 Description ] See: Description and Operation/Battery Charger 5903 Description.
-
Using INFO, set the mode of operation that corresponds with the battery.
The symbol - 1 - for service charge of wet batteries or the symbol - 2 - for service charge of Gel/Absorbant Glass Mat (AGM) batteries is indicated in
the display.
-
Set the capacity (Ah) of the battery to be charged with the corresponding button Up [Up Arrow] or down [Down Arrow].
-
Clamp the red charging clamp + to the positive battery terminal.
‹› In the case of vehicles with a start/stop function and an installed battery monitoring control module (J367), the black charge terminal - must be
connected to the body ground. The start/stop system will malfunction if it is connected to the negative terminal on the battery.
-
Connect the black charging clamp - to the negative battery terminal.
-
Press the START / STOP for approximately 5 seconds. The menu selection charging severely discharged batteries/support mode is activated.
-
Press corresponding button Up [Up Arrow] or down [Down Arrow], to set respective battery voltage (6 V, 12 V or 24 V).
‹› If no button is touched within 5 seconds, the charger will return to the main menu (operation mode selection).
-
Confirm the selected battery voltage by pressing START / STOP.
Then the inquiry about the correct polarity of the charger clamps is made.
-
Verify that the charger clamps are connected to the correct polarity.
-
Confirm that the charger clamps are connected to the correct polarity by pressing START / STOP.
The charger begins charging the severely discharged battery.
End battery charging process:
-
Press START / STOP.
-
Remove the black charging clamp - of the charger from the negative battery terminal.
-
Remove the red charging clamp + of the charger from the positive battery terminal.
-
Pull out the electrical system connector of the charger.
Battery Charger VAS 5903, Support Mode
Battery Charger VAS 5903, Support Mode
General Information:
