Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Pull the steel wire - 2 - out of the lock cylinder - 1 - and verify that the lock cylinder is securely seated in the steering lock housing.
-
Install all the components in reverse order of removal.
Ignition Switch
CAUTION!
When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information. Refer to => [
Battery, Disconnecting and Connecting ] See: Tools and Equipment/Battery, Disconnecting and Connecting.
Removing:
CAUTION!
‹› The airbag could deploy.
‹› The airbag could deploy if the airbag unit is handled incorrectly.
‹› Observe safety precautions when working on the airbag.
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Tools and Equipment/Battery, Disconnecting and Connecting.
-
Remove steering wheel.
-
Remove steering column trim.
-
Disconnect harness connector - 2 - from ignition/starter switch - 1 -.
-
Release ignition/starter switch using a small screwdriver - arrows -.
-
Pull out ignition/starter switch - 1 - from steering lock housing.
Installing:
-
Insert ignition/starter switch into steering lock housing until it engages audibly.
-
Insert ignition key into lock cylinder and turn it into position Drive.