Golf L4-2.0L DSL Turbo (CJAA) (2010)
Removing:
CAUTION!
‹› Before drilling out shear bolts, always ensure all components secured to base carrier are removed beforehand.
‹› By drilling out, drill shavings can reach the neighboring components, which can lead to damage and / or malfunctions!
‹› When removing steering column switch components, observe specified sequence. Refer to => [ Steering Column Switch Components
with KESSY ]. See: Steering Column Switch Components With KESSY
CAUTION!
When disconnecting and connecting battery, the procedure must be followed as described in the Repair Information. Refer to => [
Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery, Disconnecting and Connecting.
‹› The shear bolts - 1 - on the electronic steering column lock control module must be drilled out in order to remove the steering column switch base
carrier - 2 -. New shear bolts will be needed later for installing.
Removing:
-
Disconnect battery. Refer to => [ Battery, Disconnecting and Connecting ] See: Starting and Charging/Tools and Equipment/Battery,
Disconnecting and Connecting.
-
Remove all components secured to the base carrier in the specified sequence. Refer to => [ Steering Column Switch Components with KESSY ].
See: Steering Column Switch Components With KESSY
After components secured to base carrier have been removed, the base carrier can be removed:
-
Drill out the shear bolts - 1 - on the electronic steering column lock control module - 3 -.