Golf L4-2.0L DSL Turbo (CJAA) (2010)
Installing
-
Insert ball joint into wheel bearing housing.
-
Install new self-locking nut, and counter-hold with internal TORX bit (T40).
-
Install drive axle in wheel hub.
-
Tighten nuts - arrows -.
‹› Make sure that the ball joint boot is not damaged or twisted.
-
Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Wheels and Tires/Wheel Fastener/Specifications/Wheel Bolt
Tightening Specification.
-
Tighten drive axle bolt to wheel hub. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service
and Repair.
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
Tightening Specifications