Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-824006.png)
-
Insert coupling rod - 1 - in trailing link, do not tighten nut yet.
-
Let down wheel suspension again using (V.A.G 1383 A) and remove (T10149) from wheel hub.
-
Tighten bolts - arrows - for longitudinal control arm to tightening specification, observe required position of components while doing so.
-
Connect the coupling rod - 1 - to the wheel bearing housing and stabilizer bar.
Bolting at wheel bearing housing may occur only when the dimension between wheel hub center and lower edge of wheel house, has been
attained. Refer to => [ Before lifting the axle on
one side, the vehicle must be secured on both sides to the lift arms of the
lift using. ] See: Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive (AWD).
-
Install brake carrier with brake caliper.
-
Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Wheels and Tires/Wheel Fastener/Specifications/Wheel Bolt
Tightening Specification.
Tightening Specifications
