Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-843002.png)
‹› Locating, refer to => [ Securing Console ] See: Subframe/Front Subframe/Service and Repair/Procedures/Front Suspension.
‹› If a console is replaced, alignment must be checked. Refer to => [ Wheel Alignment ] See: Alignment/Service and Repair/Wheel Alignment.
4
Mounting Bracket
‹› Locating, refer to => [ Securing Mounting Bracket ] See: Subframe/Front Subframe/Service and Repair/Procedures/Front Suspension.
‹› With bonded rubber bushing
5
Bolt
‹› 50 Nm + 90° turn
‹› Always replace after removal.
6
Bolt
‹› M12 x 1.5 x 90
‹› 70 Nm + 90° turn
‹› Always replace after removal.
7
Bolt
‹› M12 x 1.5 x 90
‹› 70 Nm + 90° turn
‹› Always replace after removal.
8
Left Front Level Control System Sensor (G78)
‹› Removing and installing, refer to => [ Front Left Level Control System Sensor ] See: Sensors and Switches - Suspension/Ride Height
Sensor/Service and Repair/Front Suspension/Front Left Level Control System Sensor.
‹› Can be checked in Guided Fault Finding using the Vehicle diagnosis, testing and information system (VAS 5051).
9
Bolt
‹› 9 Nm
10
Wishbone
‹› It is possible there are different control arm versions (steel, aluminum).
‹› Do not install control arms made of different materials on the right and left sides.
‹› Replace with ball joint if damaged.
‹› Removing and installing, refer to => [ Control Arm with Mounting Bracket ] See: Control Arm/Service and Repair/Front Suspension/Control
Arm With Mounting Bracket.
‹› Replace bearing. Refer to => [ Control Arm Bonded Rubber Bushing ] See: Control Arm/Control Arm Bushing/Service and Repair.
11
Wishbone
‹› It is possible there are different control arm versions (welded sheet steel, single sheet steel).
‹› It is permissible to interchange control arms welded sheet steel, single sheet steel, from right to left.
‹› Replace with ball joint if damaged.
‹› Removing and installing, refer to => [ Control Arm with Mounting Bracket ] See: Control Arm/Service and Repair/Front Suspension/Control
