Golf L4-2.0L DSL Turbo (CJAA) (2010)
Suspension Control Module: Service and Repair
Electronic Damping Control Module
Electronic Damping Control Module
Removing
‹› Component location: Behind the right side luggage compartment trim.
-
Switch off all electrical consumers.
-
Remove the ignition key.
-
Remove the right luggage compartment side trim.
-
Release and disconnect the connector.
-
Push the tabs on the bracket - arrows - to the side and slide the electronic damping control module (J250) in - direction of arrow - out of the
bracket.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Slide the electronic damping control module far enough into the bracket so that the tabs - arrows - audibly latch into place.
-
Connect the connector.