Golf L4-2.0L DSL Turbo (CJAA) (2010)
‹› Observe tightening sequence. Refer to => [ Position: Threaded Connection
of Trailing Link/Wheel Bearing Housing ] See: Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive (AWD).
‹› Always replace after removal.
6
Trailing Link
‹› Removing and installing, refer to => [ Trailing Arm with Mounting Bracket ] See: Service and Repair/Removal and Replacement/Rear
Suspension/All Wheel Drive (AWD).
‹› Servicing, refer to => [ Trailing Arm Bonded Rubber Bushing ] See: Service and Repair/Removal and Replacement/Rear Suspension/All
Wheel Drive (AWD).
7
Drive Axle
‹› Assembly overview, refer to => [ Drive Axle Assembly Overview ].
‹› Removing and installing, refer to => [ Drive Axle ] See: Service and Repair/Removal and Replacement/Rear Suspension/All Wheel Drive
(AWD).
8
Bolt
‹› 70 Nm + 90° turn
‹› Always replace after removal.
9
Wheel Bearing Housing
‹› Removing and installing, refer to => [ Wheel Bearing Housing ] See: Service and Repair/Removal and Replacement/Rear Suspension/All
Wheel Drive (AWD).
10
Right Rear ABS Wheel Speed Sensor (G44)/Left Rear ABS Wheel Speed Sensor (G46)
‹› Can be tested in Guided Fault Finding using the Vehicle diagnosis, testing and information system (VAS 5051)
‹› Before inserting sensor, clean inner surface of mounting hole and coat with Polycarbamide grease (G 000 650)
11
Bolt
‹› 8 Nm
12
Bonded Rubber Bushing
‹› Replacing, refer to => [ Wheel Bearing Housing Bonded Rubber Bushing ] See: Service and Repair/Removal and Replacement/Rear
Suspension/All Wheel Drive (AWD).
13
Nut
‹› 45 Nm
‹› Self-locking
‹› Always replace after removal.
14
Bolt
‹› 50 Nm + 45° turn
‹› Always replace after removal.
15
Bolt
‹› 4 Nm
16
Brake Rotor