Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Remove wheel bearing unit from wheel bearing housing.
Installing
Installation is performed in the reverse order of removal.
-
Install brake caliper.
-
Tighten drive axle bolt to wheel hub. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service
and Repair.
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
-
Install ABS wheel speed sensor.
-
Install wheel and tighten. Refer to => [ Wheel Bolt Tightening Specification ] See: Maintenance/Wheels and Tires/Wheel
Fastener/Specifications/Wheel Bolt Tightening Specification.
Tightening Specifications
Wheel Bearing Unit, 4-Point Mount
Wheel Bearing Unit, 4-Point Mount
Special tools, testers and auxiliary items required
‹› Torque wrench (V.A.G 1332)
Removing
-
Remove the drive axle bolt. Refer to => [ Drive Axle Twelve-Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and
Repair.
‹› Vehicle must not be standing on its wheels when doing this, otherwise wheel bearing will be damaged.
-
Remove wheel.
-
Remove brake caliper and engage on body with wire.