Golf L4-2.0L DSL Turbo (CJAA) (2010)
Differential Output Shaft: Service and Repair
Left Flange Shaft and Seal
Left Flange Shaft and Seal
Special tools, testers and auxiliary items required
‹› Slide Hammer-Complete Set (VW 771)
‹› Puller (VW 771/37)
‹› Thrust Piece (3305)
‹› Torque Wrench (5-50 Nm) (V.A.G 1331)
‹› Torque Wrench (40-200 Nm) (V.A.G 1332)
Removing
‹› Transmission is installed.
-
Remove the let wheel.
-
If installed, remove the center and left part of the insulation below the engine/transmission.
-
Turn the steering fully to the left lock.
-
Remove the drive axle from the flange shaft.
-
Mark the installed position of bolts/nuts - 1 -.
-
Remove the bolts/nuts - 1 -.
-
Tie up the drive axle as high as possible. Do not damage the paint on the axle shaft when doing so.
-
Place an appropriate receptacle underneath the transmission.
-
Remove the bolt for the flange shaft, by installing two bolts into the flange and counter-holding the flange shaft using a pry bar.