Golf L4-2.0L DSL Turbo (CJAA) (2010)
-
Remove the stub or flange shaft together with the compression spring.
-
Pry out the seal.
Installing
-
Lightly oil the new seal on the outer circumference.
-
Fill the area between the sealing lip and dust lip halfway with sealing grease (G 052 128).
-
Using (3377), drive the new seal in until seated, be sure not to distort the seal.
-
Instal the stub or flange shaft.
-
Install the new bolt and tighten it to 30 Nm.
Vehicles With a Intermediate Shaft
-
Replace the O-ring on the stub shaft.
-
Grease the splines on the stub shaft using grease for clutch disc splines (G 000 100).
-
Guide the intermediate shaft - B - through the mounting bracket - C - onto the transmission stub shaft.