Golf L4-2.0L DSL Turbo (CJAA) (2010)
/Page-556002.png)
Tightening specification: 8 Nm.
-
Raise the vehicle.
-
Remove the heat shield. This way removal is easier later.
-
Remove the lock washers - A and B -. The lock washers must later be replaced when adjusting cable.
Loosen the adjustment bolt - arrow -.
-
Put the vehicle and the transmission in the "P" position before installing the cable.
-
In order to remove the cable and/or selector mechanism, the heat shield and if necessary other exhaust system components must now be removed.
-
Remove the selector mechanism.
