Golf L4-2.0L DSL Turbo (CJAA) (2010)
Power Window Control Module: Description and Operation
Data Bus on Board Diagnostic Interface, Gateway
Control Modules
Data Bus On Board Diagnostic Interface, Gateway
‹› Additional information:
423Golf 2009
Owner's Manual
General description:
The Data Bus On Board Diagnostic Interface (J533 ) (Gateway) is designed as a separate control module. It has the following tasks in the vehicle:
‹› Perform data exchange between CAN-Bus systems Powertrain CAN-Bus, Convenience CAN-Bus and Infotainment CAN-Bus
‹› Transfers diagnostic data of CAN-Bus systems onto K-wire and vice-versa, allowing the data from the vehicle tester to be used
‹› If Data Bus On Board Diagnostic Interface is to be replaced, the work procedure Replace Data Bus On Board Diagnostic Interface must always be
performed to read out the codes stored in the module => [ Data Bus On Board Diagnostic Interface ] See: Body and Frame/Body Control
Systems/Body Control Module/Service and Repair.
There is the possibility to trace whether to replace individual partial busses (powertrain, comfort and infotainment) during bus rest period (Sleep
Mode) => [ Bus Activity, Checking ] See: Body and Frame/Locks/Door Locks/Door Module/Testing and Inspection.
Furthermore, there is the possibility to check the status of the connection from Data Bus On Board Diagnostic Interface to another bus participant.
DTC recognition and display:
Data Bus On Board Diagnostic Interface is equipped with OBD which assists troubleshooting.
The Guided Fault Finding function is to be used for troubleshooting of one of the systems described as in chapter Vehicle Diagnosis, Testing and
Information System. Refer to => [ Vehicle Diagnosis, Testing and Information Systems ] See: Power and Ground Distribution/Wiring Harness/Service
and Repair/Procedures/Vehicle Diagnosis, Testing and Information Systems.
Driver Door Control Module
Control Modules
Driver Door Control Module
‹› Driver Door Control Module (J386) and Driver Window Regulator Motor (V147) comprise a single component and cannot be replaced
individually.
‹› If Driver Door Control Module or Driver Window Regulator Motor is to be replaced, the work procedure Code driver side door control module
must then be performed. Refer to => [ Driver Door Control Module, Coding ] See: Body and Frame/Locks/Door Locks/Door Module/Testing and
Inspection.
‹› Additional information:
423Golf 2009
Owner's Manual
Front Passenger Door Control Module
Control Modules
Front Passenger Door Control Module