Golf GL L4-2.0L (AEG) (2001)
^
Remove passenger side sill panel trim.
^
Lift rear seat and remove cover for fuel pump/fuel gauge sensor.
Engine overlay harness, preparation
Prior to installing the engine overlay harness, prepare the harness as follows:
^
Locate single wire portion of engine overlay harness.
^
Cut terminal and wire approx. 5cm (2 in.) from terminal end (SAVE for reinstallation at a later point in procedure).
Vehicles without Climatronic:
^
Cut ambient temperature sensor wire and tape back to harness (see above - Unused wiring, taping back to harness).
^
Locate two wire portion of engine overlay harness.
^
Locate guide tube from kit, cut one end at sharp angle.
^
Insert one wire from two wire portion of engine overlay harness into guide tube and tape second wire over guide tube using vinyl tape.
Engine overlay harness, installing