Golf GL L4-2.0L (AEG) (2001)
^
Remove pin (brown/white wire) from cavity 9 (black arrow) of this connector.
^
Cut connector from brown/white wire removed from cavity 9, then, fold loose wire end back to harness and secure with vinyl tape (see above -
Unused wiring, taping back to harness).
^
Insert terminal / wire (5 cm) previously removed (see above - Engine overlay harness, preparation) from engine overlay harness into cavity 9.
^
Reattach single wire portion of engine overlay harness (previously removed) to pin 9 of (10 or 14 pin) connector using wire splice Part No:
111971941A (shorten wire to achieve correct length).
^
Reconnect connector.
^
Continue harness routing down cable channel. then loop behind channel and route to bulkhead.
^
Reinstall cable channel cover.
^
Push guide tube through main harness (arrow) into vehicle interior at bulkhead.
From inside vehicle, behind relay panel:
^
Pull guide tube with overlay harness inside vehicle.
^
Continue routing two wire portion of engine overlay harness along main harness towards instrument cluster following original harness route along
cross member (DO NOT secure with tape at this time).
^
Remove guide tube from harness.