Golf GL L4-2.0L (AEG) (2001)
-
Press -C- button and enter correct adaptation value again.
If the displayed kilometer reading in instrument cluster is OK:
-
Press -Q- button to confirm input.
Indicated on display:
Channel 9 Adaptation 8963
Q
Store changed value?
-
Press -Q- button to confirm input.
Indicated on display:
Channel 9 Adaptation 8963
->
Changed value is stored
-
End odometer adaptation by pressing -> button.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -6- to select "End Output" function 06.
Indicated on display:
Rapid data transfer
Q
06 End Output
-
Press -Q- button to confirm input.
Indicated on display:
Rapid data transfer
Help
Enter address word XX
The tester is now in basic function again.
Distance impulse number (K number), reading/confirming
Distance impulse number can only be read/confirmed on VDO instrument clusters.
NOTE:
-
The distance impulse number is a constant used to calculate the speed indication and distance travelled.
-
The distance impulse number (K number) cannot be changed using the "Adaptation" function. To change the distance impulse number, a code that
corresponds to the vehicle engine/gearbox combination must be entered using "Code Control Module" function 07.
-
For instrument clusters with mile indicators, the distance impulse number is shown in kilometers. The trip impulse number for mile values can be
calculated as follows: Trip impulse number for kilometer values x 1.609 = trip impulse number for mile values.
-
Press the -C- button on the VAG 1551 to abort the "Read distance impulse number" function.
-
Connect scan tool VAG 1551, select operating mode 1 "Rapid data transfer", switch on ignition and enter address word 17 "instrument cluster".
-
Press -Q- button to confirm input.
-
Press -> button until "Select function" appears in display.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -1- and -0- to select "Adaptation" function 10.
Indicated on display:
Rapid data transfer
Q