Golf GL L4-2.0L (AEG) (2001)
Idle Speed: Testing and Inspection
Idle Speed, Checking
Idle Speed, Checking
NOTES:
-
Idle speed, ignition timing and CO content are not adjustable.
-
The idle speed is regulated to specified value by the throttle position sensor in conjunction with the DIS function.
-
CO content regulated by Oxygen Sensor (O2S) control. Malfunctions in oxygen sensor control are detected in On Board Diagnostic (OBD) and
stored as DTCs in DTC memory.
Special tools and equipment
-
VAG1551 Scan Tool (ST) or VAG1552 mobile scan tool with VAG1551/3 adapter cable
Test requirements
-
Exhaust system between Three Way Catalytic Converter (TWC) and cylinder head must be free of leaks
-
All electrical consumers (e.g. lights and window defroster) must be switched off
-
A/C switched off
-
Automatic transmission selector lever in "P" or "N" position
-
Cruise control system functioning correctly (if installed).
-
Accelerator pedal cable adjustment OK.
-
Coolant temperature at least 85°C, See display group 04, display field 3.
-
Intake air temperature less than 60°C See display group 04, display field 4.
Test sequence
-
Connect VAG1551 (VAG1552) Scan Tool (ST). See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading
and Clearing Diagnostic Trouble Codes/Scan Tool Connecting
-
Switch ignition on and press buttons -0- and -1- to insert "Engine Electronics" address word 01 (when doing this engine must be running at idle).
-
Check DTC memory. If necessary, repair any malfunctions and erase DTC memory.
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading
Diagnostic Trouble Codes
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Clearing
Diagnostic Trouble Codes
-
Display readiness code. If DTC memory has been erased or the Engine Control Module (ECM) was disconnected from permanent battery (B+)
voltage, the readiness code must be generated again. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
-
Leave VAG1551 Scan Tool (ST) connected.
-
Continue running engine at idle speed.
Indicated on display
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -4- to select "Basic Setting" function 04 and press -Q- button to confirm input.
Indicated on display
Basic setting
Input display group number XXX
-
Press buttons -0-, -0- and -1- to input display group number 1(001) and press -Q- button to confirm input.
Indicated on display: (1-4 = display fields)
System in basic setting 1
->
1
2
3
4
NOTE: In the "Basic Setting" function the Evaporative Emissions (EVAP) canister purge regulator valve -N80- is closed and the air conditioner
compressor is switched off.
-
Check adjustment conditions for basic setting in display field 4.