Golf GL L4-2.0L (AVH) (2002)
-
Apply adhesive tape to the instrument panel under seat heater switch -1- or the blank cover if the vehicle does not have heated seats and using a flat
screw driver -A-, remove the seat heater switch or cover.
-
Insert assembly tool T10034 into seat heater switch opening, release the clip holding the ESP or ASR switch -2- and pull it out of instrument panel
^
Insert assembly tool T10034 into ESP or ASR switch opening, release the clip holding the emergency light switch -3- and pull it out of instrument
panel.
^
Disconnect connector from the emergency light switch
^
On new emergency light switch (1J0 953 235 J 01C) reconnect connector and install switch into instrument panel
^
Reinstall ESP or ASR switch and seat heater switch into in the instrument panel and remove adhesive tape
^
Check turn signal and emergency light switch for correct operation
^
Check all turn signal and emergency light switch bulbs for illumination and replace as required
^
Destroy and properly dispose of removed part(s)